// local systems

Connect

RF Lab’s local repeaters, talk groups, and mesh — and everything you need to get on them. Wisconsin-rooted, but the setup works anywhere.

Join the Discord shortcut: join.rflab.io
// voice & radio

Repeaters & talk groups

Our local machines on the traditional bands. Program these in and call out.

GMRS repeater

“Bruce”

Our local GMRS repeater. Set the DCS access code and you’re on — far more reach than simplex.

  • Output462.675 MHz
  • Tone (in / out)DCS D445 / D445
  • ChannelGMRS 20
DMR talk group

RF Lab

A talk group links every repeater and hotspot subscribed to it. Key this TG on your DMR radio or hotspot to land in the RF Lab room.

  • Talk groupTG 3111077
Live feed

Hear Bruce, live

Live audio and auto-transcribed calls heard on the repeater — powered by our SDRTrunk-to-Text scanner.

Open the full feed ↗

New to tones? DCS (Digital Coded Squelch) is a quiet code your radio sends so the repeater opens up for you. Bruce uses D445 — set it for transmit, and for receive too (Bruce sends the same code back).

// meshcore

Get on the mesh

Flash a node, then watch the network come alive on the maps and analyzers.

Firmware Flasher & Appmeshcore.io — flash a node, pair the companion app MeshMappercoverage map built from community wardriving pings CoreScopelive map & analyzer (open-source by Kpa-clawbot) we host LetsMesh Analyzerreal-time node, packet & coverage analytics Run an observerfeed CoreScope & the analyzers — flash & configure a node

Hop on and say hi.

Repeater nets, mesh builds, and observer setups all happen in the Discord.

Join the Discord